We've previously discussed how IDEA StatiCa Connection can help you with issues such as anchor misalignment, base plate cutouts, and other field adjustments. By enabling efficient analysis and design verification, IDEA StatiCa helps to significantly reduce project delays.
However, one common solution that wasn't discussed then is the usage of post-installed anchors, specifically adhesive (epoxy anchors). These anchors are a quick and reliable solution for engineers and contractors. With the new interoperability of IDEA StatiCa Connection and Detail, using adhesive anchors is now easier than ever, and the simulation of the actual effect is more accurate.
Solution review
In IDEA StatiCa Connection, you can model customized base plates and anchor arrangements. In cases where you need to model a combination of existing cast-in-place anchors and newly proposed epoxy anchors, because they are still close to the base plate, you can set them up in IDEA StatiCa as follows:
If you choose not to consider the misaligned bolts, you can model the base plate using only the epoxy anchors.
Once you run the analysis, you can observe the forces on the anchors and the code checks. However, as the report shows, the post-installed anchors:
However, by integrating Detail 3D in the design process, you can now check all the requirements mandated by the code. Simply export the analyzed model to Detail for further analysis.
